Hook up swamp cooler
You will have to slide a screw cap onto the tubing followed by a small metal ring. Your email address will not be published. Refer to above diagram The green ground wires never carry electricity.
Unscrew the valve a little to make sure that water comes out and then shut it off until the connection is completed. Turn on the cooler and check the pump and fan motor for proper operation: If there is a lot of buildup inside the unit, consider using a descaling or cleaning product designed for use on evaporative coolers.
Aug 16, 7. Turn the pump on for 10 minutes to thoroughly wet the pads before use. They work by screwing on to the existing faucet and adding a second faucet for a hose and a side mount for the swamp cooler line to connect to.
Often the best route for your swamp cooler wiring and water line between mechanical room and the attic is the flue chase. Your swamp cooler is ready for summer!
Turn on the water and hook up swamp cooler for leaks. Here are pictures of me hooking one up. During the summer, it worked ok, but at least every 3 weeks, it would ice up and I'd be stuck with no cooling for days as they fixed it CasuistAug 16, A degree attic with blown in insulation is not a pleasant place to be crawling around, pulling wires and water lines.
The badoo online dating from a flue can melt the outer coatings of the wire, and is a fire hazard. Make sure that the water line is not touching the flue.
The cool settings hi or lo is full operation with pump wetting the pads and blower distributing cooled air into the residence. To "de-winterize" and get your evaporative cooler ready for the warm months, start by removing the cover or tarp from around the unit.
Follow a path that hides the tubing as much as possible. You are using an out of date browser.
Continue to 2 of 8 below.